# Appendix

## **Verified Supported Hardware**


:::info
*Note: Due to the sheer volume of boards and sensors that are capable of being used it is impossible to test each one and verify that it will work as a drop-in replacement.  Due to this fact this guide is written based around the commonly available BigTreeTech hardware. If a board or sensor is not listed that does not indicate that it will not work.*

:::

### **Mainboards**

* BigTreeTech Octopus and Octopus Pro v1.1
* BigTreeTech SKR Mini E3 V3
* BigTreeTech SKR V1.4 Turbo

### **Toolboards**

* BigTreeTech EBB36
* ELEGOO Centauri Carbon stock toolboard

### **Auto Bed Leveling Sensors**

* BigTreeTech Eddy Coil and Eddy Duo

### **Filament Sensors**

* BigTreeTech SFS v2.0

## **Kalico Board Configurations**

### Mainboard with stock toolboard

Check <https://git.devminer.xyz/DevMiner/elegoo-centauri-klipper>.

### Mainboard with replacement toolboard

> ⚠️ Make sure to download the additional .cfg files from the repository.

* [CANBUS Setup Guide](https://canbus.esoterical.online/)
* [Octopus v1.1 EBB36 Gen 1 v1.1 CAN Config](https://git.devminer.xyz/cyberbin/Centauri-Klipper/src/branch/main/printer_data/config/printer.cfg)
* [Eddy Duo CAN Config](https://git.devminer.xyz/cyberbin/Centauri-Klipper/src/branch/main/printer_data/config/printer.cfg)
* [Macros Config](https://git.devminer.xyz/cyberbin/Centauri-Klipper/src/branch/main/printer_data/config/macros.cfg)
* [Utility_Macros Config](https://git.devminer.xyz/cyberbin/Centauri-Klipper/src/branch/main/printer_data/config/utility_macros.cfg)

## Printables

* [EBB36 top mount toolboard](https://www.printables.com/model/1527635-ebb36-centauri-carbon-top-mount) (Designed for Gen 1, may work with Gen 2, untested)
* [EBB36 toolboard mount](https://s3.devminer.xyz/archive/ebb36_mount_v12.3mf) (use is strongly discouraged will damage board)
* Omron SSR replacement:
  * Recommended SSR: Omron G3NB-210B-1
  * [Clamp](https://s3.devminer.xyz/archive/ssr_bar_clamp_v1.stl)
  * [Mounting adapter](https://s3.devminer.xyz/archive/ssr_mount_adapter_v1.stl)